How to disassemble the rotary faucet?
January 11 , 2023
1. If the hot and cold water faucet is controlled by a main water inlet valve, close the main valve. When the hot and cold water inlet pipes are separated, then close the corresponding two valves.
2. Use a flat-blade screwdriver to open the accessory "01 hot and cold mark (handle fixing screw hole plug)" shown above;
3. Use a flat-blade screwdriver to insert into the hole plug (cold and hot mark hole) of the handle fixing screw, and turn the screwdriver counterclockwise (left-handed) for about 3 turns;
4. Grasp the handle of the faucet with the left hand, push it upwards, and at the same time use the handle at the back end of the screwdriver (must be non-metallic, otherwise it will damage the outer surface of the faucet) to gently tap upwards, so that the accessory "02 water outlet handle" is separated;
5. Counterclockwise (left-handed) accessory "03 end cap", the end cap is separated from the main body;
6. Place the opening of the adjustable wrench at the hexagonal position of the accessory "04 core body tightening hexagonal sleeve", adjust the size of the opening of the adjustable wrench, turn it counterclockwise, and remove the ceramic valve core for inspection. If it is intact, turn it clockwise (right-handed), and tighten Stop and work hard; if damaged, replace the spool with a new one.
7. Put back the accessories "03 end cap", "02 water outlet handle", "01 hot and cold mark (note that red represents the hot water side, and blue represents the cold water side)".
Choose D & S Faucets, we will provide you with the best service.